Bur Cam Pumps Inc 1/3 Hp Laundry Tub Pump 300514W Sewage & Effluent Pumps Review

Average Reviews:

(More customer reviews)I have very little plumbing experience but I found the pump to be relatively easy to install. The pump itself screws directly to the laundry tub using the supplied union coupling. Then all I had to do was connect the supplied check valve and ball valve and run PVC piping to the drain line. Installation took less than an hour. Works as described so far, just make sure your connections are tight to prevent leaks.

Click Here to see more reviews about: Bur Cam Pumps Inc 1/3 Hp Laundry Tub Pump 300514W Sewage & Effluent Pumps

1/3 HP, Automatic Laundry Tub Pump, Automatic Switch Starts Motor When Water Enters In The Pump Body, Mounts Directly To Tail Piece, Union, Check Valve & Discharge Valve Included, No Trap Or Inlet Piping Required, No Vent Connection Required, Thermal & Overload Protection, Fits Under Wet Bars, Kitchenettes, Vanities & Utility Sinks, Maximum Water Temperature 140°ree. Fahrenheit.

Buy cheap Bur Cam Pumps Inc 1/3 Hp Laundry Tub Pump 300514W Sewage & Effluent Pumps now.

LTA-1-ABC HARTELL DIRECT MOUNT SINK, Automatic laundry tray pump w/8 foot cord & plug Review

Average Reviews:

(More customer reviews)This was a direct replacement of the same type pump that quit working after many years of use. I looked into replacing the pump with one that has the waste water drain into a "box" which contains a pump - however that requires the installation of a vent pipe - vented to the outside - which was an unworkable option in my case. So I went with the direct replacement. I was impressed that the new pump came with most of the PVC fittings I needed to install it including the checkvalve and a 1/4 turn shutoff. The 1/4 shutoff is especially important because not only does it allow you to shut off any drain water back filling to the pump in the event you need to remove/replace it, but because you use the valve to "trim" the backpressure on the pump so that it doesn't cycle on and off continuously. My previous installation didn't have this and I believe it contributed to the pump eventually failing. Additionally the "kit" included a steel "strainer" that fits into the drain throat of the washbasin to catch larger debris to keep it from getting into the impellor. I recommend you pick up a PVC coupling / fitting before you install it, and then put it at the end of a 2 or 3" piece of PVC connected to the pump outlet and then put all the other hardware (check valve, shutoff valve etc) over on the other side of the coupling. That way if you have to take the pump off again in the future you can do so without having to hacksaw through the PVC pipe and then buy new hardware and fittings and cement it all back together again - instead you should loosen the coupling and then you can take the pump off by itself and then spin out the threaded fitting from the pump outlet.

Click Here to see more reviews about: LTA-1-ABC HARTELL DIRECT MOUNT SINK, Automatic laundry tray pump w/8 foot cord & plug

The LTA pumps are completely self contained units that are easy to connect directly to laundry tray tubs. Lightweight and compact, these models eliminate reservoirs, traps, extra fittings, and costly labor. This pump includes a pressure activated switch that turns on the pump when water enters the tub. 1/8hp @ 1670 RPM.115 VOLT 2.2 AMPS.

Buy cheap LTA-1-ABC HARTELL DIRECT MOUNT SINK, Automatic laundry tray pump w/8 foot cord & plug now.